HW309

Live Chat Ask A Question View Spec Sheet

Application:

For use in harsh environments where maximum conductor protection is required. Used for primary power and feeder circuits in a broad range of commercial and industrial power distribution systems. Approved for use in wet or dry locations at 90°C, for installation indoors or outdoors, aerially, in conduits, ducts, cable trays or direct burial in circuits not exceeding 5000 volts. UL listed, Type MC-HL per UL 2225 for use in Class I, Division I hazardous locations. UL approved for use at 90°C for continuous operation, 130°C for emergency overload conditions, and 250°C for short circuit conditions. Impervious continuously welded and corrugated aluminum armor cable is recommended as an economical alternative to wire in conduit systems.

Conductors

Soft bare annealed copper per ASTM B-3, compact Class B stranding per ASTM B-8, with a semi-conducting conductor shield

Insulation

Ethylene propylene rubber (EPR) per ICEA S-97-682/S-93-639

Grounding Conductor

Soft bare annealed copper per ASTM B-3, Class B stranding per ASTM B-8 sized in accordance with UL 1072

Armor

Impervious continuously welded and corrugated aluminum

Jacket

Yellow flame-retardant and sunlight-resistant PVC

Flame Tests

ICEA (70,000 BTU/hr) and (210,000 BTU/hr) Flame Test
IEEE 1202 Flame Test

Color Code

ICEA Method 4

Additional Standards

Single conductors are qualified per AEIC CS8
Meets requirements of CSA-C22.2 No. 0.3, -40°C cold impact test
UL listed Type CWCMC to IEEE 45/IEEE 1580 (46 CFR Part 111.60-23) Marine Shipboard Cable

Connectors

Explosion Proof, Class I Division 1: 424MA series – all nickel-plated aluminum
Rain Tight: 416MC series – all nickel-plated brass

Browse HW309 Products

Products
>
Products
>
HW309: 2.4kV CCW Non-Shielded Cable, Type MC-HL

HW309: 2.4kV CCW Non-Shielded Cable, Type MC-HL

For use in harsh environments where maximum conductor protection is required. Used for primary power and feeder circuits in a broad range of commercial and industrial power distribution systems. Approved for use in wet or dry locations at 105°C, for installation indoors or outdoors, aerially, in conduits, ducts, cable trays or direct burial in circuits not exceeding 15000 volts. UL listed, Type MC-HL per UL 2225 for use in Class I, Division I hazardous locations. UL approved for use at 105°C for continuous operation, 140°C for emergency overload conditions, and 250°C for short circuit conditions. Impervious continuously welded and corrugated aluminum armor cable is recommended as an economical alternative to wire in conduit systems.

Loading products...