HW311

Live Chat Ask A Question View Spec Sheet

Application:

For use in harsh environments where maximum conductor protection is required. Used for primary power and feeder circuits in a broad range of commercial and industrial power distribution systems. Approved for use in wet or dry locations at 105°C, for installation indoors or outdoors, aerially, in conduits, ducts, cable trays or direct burial in circuits not exceeding 15000 volts. UL listed, Type MC-HL per UL 2225 for use in Class I, Division I hazardous locations. UL approved for use at 105°C for continuous operation, 140°C for emergency overload conditions, and 250°C for short circuit conditions. Impervious continuously welded and corrugated aluminum armor cable is recommended as an economical alternative to wire in conduit systems.

Conductors

Soft bare annealed copper per ASTM B-3, compact Class B stranding per ASTM B-496, with a semi-conducting conductor shield

Insulation

Ethylene propylene rubber (EPR) per ICEA S-97-682/S-93-639 with a semi-conducting insulation shield

Shield

Uncoated 5 mil copper tape with a minimum 12.5% overlap per ICEA S-97-682

Grounding Conductor

Soft bare annealed copper per ASTM B-3, Class B stranding per ASTM B-8 sized in accordance with UL Standard 1072

Armor

Impervious continuously welded and corrugated aluminum

Jacket

Red flame-retardant and sunlight-resistant PVC

Flame Tests

ICEA (70,000 BTU/hr and 210,000 BTU/hr) Flame Test
IEEE 1202 Flame Test

Color Code

ICEA Method 4

Additional Standards

UL listed, NEC Type MV-105 and Type MC, UL Standard 1072
Single conductors are qualified per AEIC CS8
Meets requirements of CSA-C22.2 No. 0.3, -40°C cold impact test
UL listed Type CWCMC to IEEE 45/IEEE 1580 (46 CFR Part 111.60-23) Marine Shipboard Cable

Connectors

Explosion Proof, Class I Division 1: 424MA series – all nickel-plated aluminum
Rain Tight: 416MC series – all nickel-plated brass

Browse HW311 Products

Products
>
Products
>
HW311: 15kV CCW Shielded Cable, Type MC-HL

HW311: 15kV CCW Shielded Cable, Type MC-HL

LifeGuard™ Low Smoke Zero Halogen* cable is for use in power, control and lighting circuits in a broad range of commercial and industrial applications. The impervious armor provides maximum conductor protection and prevents the entrance of water, gas and corrosive elements into the electrical core. The LifeGuard™ jacket is highly flame retardant, produces very small amounts of smoke when burned and contains no halogens. It is ideal for applications where a high degree of safety and equipment protection is required.

LifeGuard™ cable is UL listed, Type MC-LS per UL 1685 and approved for installation indoors or outdoors, aerially, in conduits, ducts, cable trays and direct burial in circuits not exceeding 600 volts. It may be installed in temperatures as low as -30°C and used in hazardous locations. It is UL approved for continuous operation at 90°C in wet and dry locations, 130°C for emergency overload conditions, and 250°C for short circuit conditions.

Impervious continuously welded and corrugated aluminum armor is recommended as an economical alternative to wire in conduit systems.

Loading products...